Williams 4505621 Instruction Manual download pdf (Page 4)

Safety Rules

WARNING 4. LOCATE the furnace out of traffic patterns as much as

READ THESE RULES AND THE INSTRUCTIONS

CAREFULLY. FAILURE TO FOLLOW THESE

RULES AND INSTRUCTIONS COULD CAUSE A

MALFUNCTION OF THE FURNACE. THIS COULD

RESULT IN DEATH, SERIOUS BODILY INJURY,

AND/OR PROPERTY DAMAGE.

possible with a minimum of 6" clearance from all

combustible walls and 15" on two adjoining sides of the

grille for passage.

5. BE SURE to provide for adequate combustion and

ventilation air. The flow of this air to the furnace must not

be blocked.

INSTALLATION MUST CONFORM TO LOCAL CODES. IN

THE ABSENCE OF LOCAL CODES, INSTALLATION MUST

CONFORM WITH THE NATIONAL FUEL GAS CODE, ANSI

Z223.1.

INSTALLATION AND REPAIR SHOULD BE DONE BY A

QUALIFIED SERVICE TECHNICIAN. THE CLEANED

FURNACE SHOULD BE INSPECTED BEFORE USE AND

AT LEAST ANNUALLY BY A PROFESSIONAL SERVICE

TECHNICIAN. MORE FREQUENT CLEANING MAY BE

REQUIRED DUE TO EXCESSIVE LINT FROM SOME

CARPETING, BEDDING MATERIAL, ETC. IT IS

IMPERATIVE THAT CONTROL COMPARTMENTS,

BURNERS AND CIRCULATING AIR PASSAGEWAYS OF

THE FURNACE BE KEPT CLEAN.

YOUNG CHILDREN SHOULD BE CAREFULLY

SUPERVISED WHEN THEY ARE IN THE SAME ROOM

WITH THE FURNACE.

6. USE joint compound (pipe dope) on threaded joints of gas

piping that is resistant to the action of liquefied petroleum

gas.

7. USE only ground joint unions in gas piping.

8. INSTALL a manual shutoffvalve and union ahead of the

controls so that the controls and furnace may be removed

for servicing, if necessary.

9. INCLUDE a 1/8 NPT plugged tapping accessible for test

gauge connection immediately upstream of the gas

supply connection to the furnace.

10. NEVER test for gas leaks with an open flame. Use soap

suds to check all gas connections. This will avoid the

possibility of fire or explosion.

11. INSTALL the furnace to a proper venting system

ANY SAFETY SCREEN, GUARD OR PARTS REMOVED

FOR SERVICING AN APPLIANCE MUST BE REPLACED

PRIOR TO OPERATING THE APPLIANCE TO AVOID

PROPERTY DAMAGE, BODILY INJURY OR DEATH.

12. DO NOT place clothing or other flammable material on

or near furnace.

13. DO NOT modify or alter the furnace cabinet in any way.

CHILDREN AND ADULTS SHOULD BE ALERTED TO THE

HAZARD OF HIGH SURFACE TEMPERATURE AND

SHOULD BE KEPT AWAY TO AVOID BURNS OR

CLOTHING IGNITION.

14. BE SURE factory installed grille is in place during

operation.

15. DO NOT connect this furnace to a chimney serving a

solid-fuel burning appliance.

1. USE ONLY MANFACTURER'S REPLACEMENT

PARTS. USE OF ANY OTHER PARTS COULD CAUSE

INJURY OR DEATH.

16. CLEAN the furnace and periodically inspect the pilot and

burner flame as described in the maintenance section of

this manual.

2. BE SURE furnace is for type of gas to be used. Check

the rating plate beneath the grille. Do not change it to

useothergases. Unsafe operationcould resultandcould

cause bodily injury and death.

3. BE SURE the furnace is installed so that the drafthood is

located in the same atmospheric pressure zone as the

combustion air inlet to the furnace.

17. DISCONNECT the furnace during supply line pressure

testing.

18. FOLLOWthe lighting and operating procedures given in

this manual.

19. WARNING: Any change to this furnace or its controls

could cause injury or death.

WARNING

DO NOT USE THIS HEATER IF ANY PART HAS BEEN UNDER WATER. IMMEDIATELY CALL A QUALIFIED |

SERVICE TECHNICIAN TO INSPECT THE HEATER AND TO REPLACE ANY PART OF THE CONTROL SYSTEM

AND ANY GAS CONTROL WHICH HAS BEEN UNDER WATER.

-4.

1 2 3 4 5 6 7 8 9 ... 19 20

Comments to this Manuals

No comments

Williams 4505621 Instruction Manual Page 4

Comments to this Manuals

Related products and manuals for Water heaters & boilers Williams 4505621