Williams 4505621 Instruction Manual download pdf (Page 12)

FOR YOUR SAFETY READ BEFORE LIGHTING

I WARNING: If you do not follow these instructions exactly, a fire or explosion I

may result causing property damage, personal injury or loss of life.

A. This appliance has apilot which must be lighted • If you cannot reach your gas supplier, call the fire

by hand. When lighting the pilot, follow these

instructions exactly.

B. BEFORE LIGHTING smell all around the appliance

area for gas. Be sure to smell next to the floor

because some gasis heavier than air and will

settle on the floor.

WHAT TO go IF YOU SMELL GAS

• Do not try to light any appliance or strike a match.

• Do not touch any electric switch; do not use any phone

in your building.

• Immediately call your gas supplier from a neighbor's

phone. Follow the gas zupplier's instructions.

department.

C, Use only your hand to push in or turn the gas

control rod. Never use tools. If the knob will

not push in or turn by hand, don't try to repair

it, call a qualified service technician. Force or

attempted repair may result in a fire or explosion.

O. Do not use this appliance if any part has been

under water. Immediately call a qualified service

technician to inspect the appliance and to replace

any part of the control system and any gas

control which has been under water.

OPERATING INSTRUCTIONS

1. STOP! Read the safety information above on

this label.

2. Set the thermostat to lowest setting.

3. With the key, depress the control rod slightly

and turn pointer clockwise _> to"OFF".

_ POINTER _'_

IGNITOR

PILOT CONTROL BUTTON

ROD

4. Wait five (5) minutes to clear out any gas.

Then smell for gas, including near the floor.

If you smell gas, STOP! Follow "B" in the

safety information above on this label.

If you don't smell gas, go to the next step.

5. Find the pilot.

PILOT -_ HoLEOBSERVATION

6. Turn the control rod counterclockwise <_

to "PILOT',

7. Position yourself so the pilot can be seen

through the observation hole. Push the control

rod down fully and hold it down. Immediately

push the ignitor button.

Push the ignitor button again at five (5) second

intervals until the pilot is lit. After the pilot is lit,

continue to hold the control rod down for

about one (1) minute. Release the control rod

and it will pop back up. The pilot should remain

lit. If it goes out, repeat steps 2 through 7.

Alternate liQhtinq with a match: Fol[ow steps

2 through 6. Remove cover from observation

hole. Place a match in lighter rod, ignite and

lower to pilot burner (through observation hole).

Depress the control rod down fully and hold it

down for about one (1) minute after the pilot

lights. Release the control rod and it will pop

back up. The pilot should remain lit. If it goes

out, repeat steps 2through 7. Replace cover on

observation hole, making sure gasket is in place.

• If the pilot will not stay lit after several tries,

depress the gas control rod slightly and turn

to "OFF", and call your service technician or

gas supplier.

• If control rod does not pop up when released,

stop and immediately call your service technician.

8. Turn the control rod counterclockwise<_ to

-ON +"

9. Set thermostat to desired setting.

TO TURN OFF GAS TO APPLIANCE!

1. Set the thermostat to lowest setting, and turn clockwise _> to "OFF'.

2. With the key, depress the control rod slightly

-12-

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments

Williams 4505621 Instruction Manual Page 12

Comments to this Manuals

Related products and manuals for Water heaters & boilers Williams 4505621